Home Archived February 20, 2019

Link to USGS home page
125 years of science for America 1879-2004
Sound Waves Monthly Newsletter - Coastal Science and Research News from Across the USGS
Home || Sections: Spotlight on Sandy | Fieldwork | Research | Outreach | Meetings | Awards | Staff & Center News | Publications || Archives


Field-Testing the New USGS Portable Auger Drilling System (PADS) in Louisiana and South Carolina

in this issue:
 previous story | next story

photo of the portable auger system
PADS: Portable Auger System (PADS) set up on North Island, SC. The power supply, which consists of a 31-horsepower gasoline engine and a 15-gallon hydraulic reservoir, is in the red frame toward the back half of the large aluminum frame.
After a year of planning and building, the U.S. Geological Survey (USGS)'s new Portable Auger Drilling System (PADS) was put into the field to test its capability in collecting continuous sediment cores. The coring system consists of a 3-inch-diameter steel barrel with plastic liner that is fixed inside a 3 1/4-inch-diameter hollow stem auger (6-inch outer diameter). The system is entirely hydraulic and is driven by a 31-horsepower gasoline engine. The superstructure is constructed of reinforced heavy-duty aluminum and is dismantled and placed in a 12-ft-long cargo trailer for transport. The system can be placed on an aluminum barge for work in shallow water or transported with the assistance of an all-terrain vehicle (ATV) to hard-to-reach environments.

The inaugural trip for the PADS was to Cocodrie and Port Fourchon, LA, over September 16-23. Phil McCarty and Mike Brown (University of New Orleans) assisted Jack Kindinger (principal investigator), Jim Flocks, Chris Reich, Nick Ferina, and Chandra Dreher (all of USGS) in testing the coring capability of the system. In Cocodrie, the first day was spent working out some of the kinks. On the second day, the PADS reached a depth of 50 ft and obtained near-continuous cores of typical deltaic sediment. The system was moved to Port Fourchon, where only 1 day of coring was conducted before having to pack up and leave because of the approach of Hurricane Isidore. All work in Louisiana was conducted from an aluminum barge in 2- to 3-ft water depth.

From October 8 to 17, Chris Reich, Nick Ferina, and Jason Greenwood (USGS) conducted drilling with the PADS at North Island, SC, a heavily wooded sand spit approximately 10 mi long by 1 mi wide, bordered by Winyah Bay to the west and the Atlantic Ocean to the east. We worked in cooperation with Eric Wright (assistant professor of marine science at Coastal Carolina University, Conway, SC) and were assisted in the field by Eric, Scott Harris (also an assistant professor at Coastal Carolina University), and five undergraduate students. Because the only access to North Island is by boat, the PADS and a four-wheel ATV were transported to the island on an aluminum barge that was driven partly up onto the beach, where the equipment and ATV were unloaded.

Site 1 was located along the axis of the island. A depth of approximately 40 ft was reached with the auger; however, no core was recovered, owing to running or flowing sands, which tend to plague most other drilling systems, as well as the PADS. Running sands occur when drilling reaches the water table and fluidized sand flows upward into the core barrel. Standard core catchers located at the base of the inner barrel cannot retain these sands. The water table was less than 5 ft deep at site 1. Because we were unable to take a core, we decided to drill to bedrock (approximately 40 ft down) and sample the sediment on the auger flights as they were withdrawn from the ground. This plan worked well. Sediment texture ranged from green-gray fine sand at the top of the hole to light-cream-colored lime mud with coarse quartz grains at the base. The lime mud is probably a residual product from weathering of the limestone bedrock.

photo of the auger system set up on an aluminum platform
Auger system set up on an aluminum platform at Cocodrie, LA.
photo of jason greenwood driving  an ATV
The only way to get drilling equipment and ATV to North Island, SC, was by barge. Here, Jason Greenwood is driving the ATV onto the barge. The PADS has been dismantled and is lying on the beach in the background.

Site 2 on North Island was on the foredune set. It took 1 day to break down the PADS at site 1 and move it over a series of large dunes with the ATV to site 2. Drilling at site 2 proved to be more difficult because the auger pipe stopped at a depth of approximately 25 ft for unknown reasons. Again, running sands kept us from obtaining any sediment cores. The auger pipe was eventually retrieved, and the PADS was dismantled and hauled back across the island to be loaded on the barge for the long boat ride back to the dock.

Overall, this system has a strong potential for work in many environments. The problem with running sands is being addressed, and solutions will be tried and tested. At present, at least five potential projects have a need for the PADS.

in this issue:
 previous story | next story


Mailing List:

print this issue print this issue

in this issue: Fieldwork cover story:
USS Arizona

Adriatic Sea Sediment-Transport Cruise

Bear Lake Sea-Floor Mapping

Assateague Island Vegetation Mapping

Field-Testing New Portable Drilling System

Research Diamondback Terrapin

Outreach Transoceanic Dust Impacts

Woods Hole Field Center Open House

St. Petersburg Field Center Open House

Great American Teach-In

Fourth-Graders Tour St. Petersburg Field Center

Girl Scouts 90th Anniversary


Meetings Effects of Fishing Activities on Benthic Habitats

Planning Gas-Hydrates Research

Science and Politics in Ecosystem Decisions

Sea-Floor Mapping Techniques

Staff & Center News GHASTLI Lab Visitors

Science Museum Board

Two New Scientists

Louisiana Coastal-Restoration Advisory Board

Air Medical Transport Center Tour

MRIB Programmer

New Webmistress

Publications Dec./Jan. Publications List

FirstGov.gov U. S. Department of the Interior | U.S. Geological Survey
Sound Waves Monthly Newsletter

email Feedback | USGS privacy statement | Disclaimer | Accessibility

This page is http://soundwaves.usgs.gov/2003/01/fieldwork4.html
Updated December 02, 2016 @ 12:09 PM (THF)